Maytag ACD2234HR*ACD2238HT Series Service page 62

Installation
Installing Front-Mounted Handles for
Stainless Steel
1. Loosen lower door clip on door with
a phillips screwdriver.
2. Locate predrilled hole at base of
handle, and fit hollow end of
handle over lower door clip.
3. Fit other end of handle over upper
door clip and slide up as far as
possible.
NOTE: If top of handle does not
fit over top clip, loosen lower clip
further until fit can be
accomplished.
4. Insert phillips screwdriver into
predrilled hole at base of handle
to tighten screw. Insert plastic
button plug into hole, as
illustrated.
5. Repeat above steps to install
other handle.
Removing Front-Mounted Handles for
Stainless Steel
1. Remove plastic button plug at
base of handle with a very small
flat-blade screwdriver.
• Insert phillips screwdriver into
predrilled hole to remove
screw.
2. Slide handle down and remove
from door clip.
3. Repeat above steps to remove
other handle.
8