Tuner Operation; Tuner Tft Display; Tuner Lcd Display; Switch To Radio Tuner Source - Jensen Mobile Multimedia AM/FM/DVD Receiver VM9410 Owner's Manual

TUNER OPERATION

Tuner TFT Display

4 1 11 2
P1
Loc
ST
7 8 9
1. Current Radio Band Indicator
2. Radio Frequency Indicator
3. Clock
4. Stereo Broadcasting Indicator
5. Strong Local Signal Broadcasting Indicator
6. Preset Radio Stations
7. Front Zone Playing Mode
8. Rear Zone Playing Mode
9. User Defined Equalizer Level
10. Loud Setting Indicator
11. Current Preset Station Indicator

Tuner LCD Display

1 2
1. Current Radio Band Indicator
2. Radio Frequency Indicator
3. Current Preset Station Indicator
4. Stereo Broadcasting Indicator
5. Strong Local Signal Broadcasting Indicator

Switch to Radio Tuner source

Press the SRC button (15) on the front panel or remote
control (8) to switch to the RADIO TUNER source. The Tuner
5 6
TFT or LCD display appears.

Select FM/AM Band

Press the BAND button (14) on the front panel or the remote
control (20) to change between the following bands: FM1,
FM2, FM3, AM1, and AM2.

Auto Tuning

Press and hold the
button on the joystick (17) to seek the next available radio
station by increasing the tuning frequency. Press the button
again to stop searching.
Press and hold the
the button on the joystick (16) to seek the next available
radio station by decreasing the tuning frequency. Press the
button again to stop searching.
3 10 10

Seek Tuning

Press the button (19) on remote control or the
the joystick (17) to seek the next station higher.
Press the button (17) on the remote control or the
button on the joystick (16) to seek the next station lower.

Manual Tuning

Press the or
the or buttons (18, 19) on the joystick to increase or
decrease the tuning frequency one step.

Using Preset Stations

Six numbered preset buttons store and recall stations for
each band. All six stored stations (P1-P6) for the current
band appear on the TFT screen.
Storing a Station
1. Select a band (if needed), then select a station.
2. Hold a preset button (8-13) for three seconds. The
3 4 5
preset number appears in the LCD panel.
Recalling a Station
1. Select a band (if needed).
2. Press a preset button (8-13) to select the corresponding
stored station.
button (19) on remote control or the
button (17) on the remote control or
button on
buttons (14, 22) on the remote control or
14

Auto Store (AS)

Automatic Storing of Preset Stations
To select six strong stations and store them in the current
band:
1. Select a band (if needed).
2. Press AS (26) for > 2 seconds to activate the Auto Store
function.
The new stations replace stations already stored in that band.
Using Preset Scan
To scan stored stations in the current band:
1. Select a band (if needed).
2. Press AS (26) for < 2 seconds. The unit pauses for 10
seconds at each preset station.
3. Press AS again to stop scanning when the desired
station is reached.

Local Radio Station Seeking (LOC)

When the Local function is on, only radio stations with a
strong radio signal are played. To activate the Local function,
press and hold the LO/DX button (6) on the front panel. Press
LO/DX again to turn Local off. When the Local function is
active, the "LOC" indicator appears lit on the LCD or TFT
screen.
VM9410