Toshiba 32L1400U User Manual page 45

To program channels automatically:
1
Configure the antenna input source, if you have not already
done so, see
2 Press the MENU button and open the Installation menu.
3 Highlight Channel Tuning, and then press the ENTER button.
(Sample Image) Setup menu - Installation selection
4 Highlight Auto Tuning, and then press the ENTER button to
open the Channel Program menu to begin channel
programming.
!
Scanning channels, please wait...
Number of Channels Found -
Scanning Analog Channels
Channel - 9
(Sample Image) Installation menu - Channel selection
The TV will automatically cycle through all the antenna/cable
channels, and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
"Scanning channels, please wait" appears.
5 To cancel channel programming, press the EXIT button on the
remote control or highlight Cancel in the on-screen display,
and then press the ENTER button.
When channel programming is complete, press the CH
▲/▼(arrow) buttons to view the programmed channels.
"ANT/CABLE IN" on page 43.
Cable
7
Cancel
Setting up your TV
6%
45