Fujitsu Primergy RX100 S3 Options Manual page 12

Safety notes
Installation and operation
V
CAUTION!
If the server is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
The server automatically sets itself to a voltage in the range of
100 V to 127 V or 200 V to 240 V. Make sure that your local voltage
is within this range.
This device has a specially approved power cable and must only be
connected to a grounded insulated socket.
The ON/OFF button does not disconnect the device from the mains
voltage. To completely disconnect it from the mains voltage, remove
the power plug from the insulated socket.
Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
the central processing unit is still running but the peripheral device
(e.g. storage subsystem) has failed during a power outage.
Data cables to peripheral devices must be adequately shielded.
To the LAN wiring the requirements apply in accordance with the
standards EN 50173 and EN 50174-1/2. As minimum requirement
the use of a protected LAN line of category 5 for 10/100 MBps
Ethernet, and/or of category 5e for Gigabit Ethernet is considered.
The requirements of the specification ISO/IEC 11801 are to be
considered.
Route the cables in such a way that they do not form a potential
hazard and that they cannot be damaged. When connecting up a
device, refer to the relevant notes in this manual.
Never connect or disconnect data transmission lines during a storm
(lightning hazard).
12 Options Guide
U41617-J-Z156-1-76