Table of Contents
Advertisement
SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
NOTE:
The system will always complete normal alarm action before executing the macro
function.
FULLSCREEN ALARM
This option allows setting the system to display only a FULLSCREEN image on Monitor-A instead of
the default multiscreen (or associated alarm camera displays) for any alarm input. See section 4.9.
NOTE: This is a global setting and will apply to ALL alarms.
RELAY CONFIGURATION
Each relay (1 & 2) can be configured for N/OPEN (normally open NO) or N/CLOSED (normally
closed NC). This menu item allows selection of either NC or NO configuration.
BUZZER SETUP
The internal buzzer is programmable to respond under various conditions. The sub-menu item under
ALARMS is as follows:
"
"
Global Buzzer
"
Live Alarm Buzzer –
"
"
"
Video loss Buzzer
"
Playback Buzzer
"
VIDEO LOSS ACTION
This option is used to specify what is to happen in the event of loss of a video input. Video loss can
occur due to a failed camera or disconnection of the video signal to the multiplexer.
Video Loss action in LIVE Mode:
Monitor-A:
If the camera is being displayed at the time that video loss occurs, the camera image
will be frozen. However, if sequencing is in progress, the display will be blanked
when it is switched to a camera experiencing video loss.
Monitor-B:
Monitor-B cannot freeze images, and so the display will always be blanked while a
camera with video loss is selected.
Video Loss action in RECORD Mode:
When video loss is detected, the affected camera is temporarily removed from the record list, and the
coded digital data recorded with each field will be updated to indicate a video loss situation on the
affected camera. This video loss status is then shown during Playback. The SW-D7000U continues
56
JVC PROFESSIONAL, IMAGING PRODUCTS
Buzzer Setup
Global Buzzer
Live Alarm Buzzer
Videoloss Buzzer
Playback Buzzer
[CANCEL]
–
Set to OFF if some Buzzer responses are not to be active.
Set to OFF if no Buzzer is desired on incoming Live Alarms.
–
Set to OFF if no Buzzer is desired on video loss detection
–
Set to OFF if no Buzzer is desired on during the playback of
Videotapes where alarms are present.
:ON
:ON
:ON
:ON
[OK]
Advertisement
Table of Contents
