Troubleshooting - Jenn-Air W10233478B Installation Instructions And Use And Care Manual

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Surface burners will not operate
Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
Is the control knob set correctly?
Push in knob before turning to a setting.
Are the burner ports clogged?
See "Sealed Surface Burners" section.

TROUBLESHOOTING

Surface burner flames are uneven, yellow and/or noisy
Surface burner makes popping noises
Continuous sparking of igniter
Excessive heat around cookware on cooktop
Cooktop cooking results not what expected
Are the burner ports clogged?
See "Sealed Surface Burners" section.
Are the burner caps and heads positioned properly?
See "Sealed Surface Burners" section.
Is propane gas being used?
The cooktop may have been converted improperly. Contact a
service technician or see "Assistance or Service" section.
Is the burner wet?
Let it dry.
Is a cross draft drawing the flame away from the igniter?
This is normal when a cross draft is present.
Is the power supply cord properly grounded/polarized?
See the Installation Instructions.
Is the burner cap and head positioned properly?
See "Sealed Surface Burners" section.
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
Is the proper cookware being used?
See "Cookware" section.
Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
Is the cooktop level?
Level the cooktop. See the Installation Instructions.
9