Connection Diagram - Sony MV-900SDS Service Manual

MV-900SDS
Where to install
Before installing this unit, please check your local traffic rules and regulations. Follow the diagram
below to install this unit in a suitable position in your car.
Do not install this unit where:
— It will obstruct the driver's view when the
monitor is in either the open or closed
position.
— It will obstruct the operation of the airbag
system.
— It will obstruct the operation of the
vehicle, especially the steering wheel, shift
lever, or brake pedal.
— A driver or passengers may injure
themselves when getting into or out of the
car.
If you have any questions or problems
concerning your unit that are not covered
in this manual, please consult your
nearest Sony dealer.
Before installing
Make sure that the POWER SELECT switch is
set to the correct position.
A*: If your car has an accessory position on
the ignition key.
B : If your car has no accessory position on
the ignition key.
* A is the factory preset position.

Connection diagram

Refer to the connection diagram for the proper connections.
Note
Set the POWER SELECT switch before installing (page 6).
Amplifier equipped
with a digital input
(optional)
From the car antenna
Antenna connector* 1
Speaker system Car audio
(optional) (optional)
* 1 An adapter (optional) may be necessary for your
car and car audio system. In such a case, consult
your dealer.
2 If your car has no ACC (accessory) position on
*
the ignition key switch, set the POWER SELECT
switch to B (page 6) and connect this ACC cable
to the +12 V power (battery) terminal.
Monitor cable (optional)
Monitor (optional)
8
When the POWER SELECT switch is
set to B
Press (POWER) on the player to turn on.
The player does not turn on by pressing
(POWER) on the card remote commander.
POWER SELECT
switch
B
A
Note
Be sure to turn off the player after driving your
car.
To turn off the player, follow the operations
below:
– Press (POWER) on the player.
– Press (POWER) on the card remote commander.
If the power is left on, it will cause battery drain.
Optical cable
(optional)
5 m
Relay box
0.5 m
AUDIO/VIDEO OUTPUT
RCA pin cord (optional)
Connection box
(optional)
Connections
Installation diagram
Refer to the installation diagram and ask a qualified technician for the installation of the unit.
Front Left
speaker
DVD player
XVM-R90D
Cordless Stereo
Headphones
MDR-IF0140
Rear Left
speaker
Subwoofer
Rear Right
speaker
Be sure to securely fasten all equipment to
the car chassis, etc., to prevent them
moving while your car is in motion.
Note
All equipment other than one DVD player and two
cordless stereo headphones is optional.
Black
Black
Yellow
Fuse (5 A)
Filter box
Red
Fuse (1 A)
Blue
4 Pin Power connector
Precautions on PS one™
• Be sure to fasten PS one™ in a safe place
securely.
• For your safety, do not use PS one™ while
driving your car.
• Make sure that the operating voltage of PS
one™ is 7.5 V. Other voltages may cause
malfunction, or damage PS one™.
Refer to the operating instructions supplied to
PS one™.
"PS one" is a trademark of Sony Computer
Entertainment Inc.
Tweeter Left
Head unit
Tweeter Right
Front Right
speaker
Notes on the locations for PS one™
Do not set PS one™:
— on a dashboard, or in a place subject to direct
sunlight.
— in a place near magnetic source such as
magnets, speakers and a TV/Monitor.
— on an unstable or uneven surface.
— in a place subject to excessive vibration.
— in a place subject to excessive dust or dirt.
— in poorly ventilated or humid place.
— in a place to subject to temperature extremes
(below 5˚C (41˚F) or above 35˚C (95˚F)).
Refer to the operating instructions supplied to PS
one™.
"PS one" is a trademark of Sony Computer
Entertainment Inc.
GND (1 m)
To a metal surface
of the car chassis
GND (1 m)
Back-up (5 m)
To car battery
(12 V)
ACC (5 m)
To ignition switch*
(ACC position)
POWER REM (5 m)
To a power
amplifier
Max. supply current 0.3 A
AUDIO/VIDEO INPUT
AV Cable
(integrated audio/video)
(optional)
PS one™ (optional)
2