Reversal Delivery Unit - Canon DADF-B1 Service Manual

CHAPTER 3 MECHANICAL SYSTEM
Caution:
The feed motor has its own orientation.
When mounting it, check to make sure
that it is oriented with the harness as
shown.
Figure 3-207-1
3-8
COPYRIGHT © 1999 CANON INC. CANON DADF-B1 REV.0 APR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
D. Reversal Delivery Unit
1. Removing the Reversal Delivery Unit
1) Remove the screw [2] used to keep the
support shaft of the delivery cover [1] in
place, and push the support shaft to detach
the delivery cover while pulling it to the
front.
Figure 3-208
2) Remove the ADF controller PCB.
3) Fit the connector on the reversal delivery
unit side into the groove.
4) Remove the five mounting screws [4], and
detach the reversal delivery unit [3].
[4]
Figure 3-209
[1]
[2]
[3]