Operation; Squelch; Memory Input; Scan Operation - Kenwood TR-7950 Instruction Manual

SECTION 3 OPERATION
3-1 BEFORE OPERATION
For frequencies outside the 144.000 - 148.000 MHz,
the transceiver operates only in the simplex mode.
3-2 SQUELCH
3.3 MEMORY INPUT
Example: Storing 144.650 MHz with +600 kHz shift and
subaudible tone "1 in memory channel 5,
3-4 CHANGING MEMORY FREQUENCIES
If you wish to change any memory frequency, store a new
frequency in that channel using the precious procedure.
The old frequency is erased when the new frequency is
stored.
3-5 SCAN OPERATION
The SCAN operation is divided into keyboard scan, me-
mory scan and priority channel scan. For SCAN operation,
the squelch control should be advanced to the threshold
point. See section 3-2 Squelch.
First, select either timer operated hold (TO) carrier (signal)
operated hold (CO) with the SCAN switch.
• MEMORY SCAN from the keyboard
1. Set the SELECT switch to M. CH.
2. Press the 1J key to initiate scanning.
The scan will beigin from the displayed channel ad-
vancing, toward the higher numbered channels. During
this operation, holding the microphone DWN switch
changes scan direction backward. Releasing the DWN
switch returns scan direction forward. Holding the UP
switch permits accelerated scanning.
12 TR79O/793O