Land Pride FDR1648 Operator's Manual page 28

Section 5: Maintenance & Lubrication
Do Not Overfill
IMPORTANT: Your mower is shipped with a vented
dipstick packaged in the Operator's Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
NOTE: Use a suction or siphon pump to drain
gearbox of oil when there is not an oil drain plug.
26 FDR1648, FDR1660 & FDR1672 Rear Discharge Grooming Mowers 310-366M
Table of Contents
30215
Gearbox
IMPORTANT: Do not overfill gearbox with oil! Oil will
expand when hot! Make sure mower is level and oil is
cool before checking oil level.
Method 1: With a wrench, unscrew top vented dipstick
(#1). Wipe oil from dipstick and screw dipstick in without
tightening. Unscrew dipstick and check oil on dipstick. If
below bottom level mark, add recommended gear lube
through dipstick hole until oil reaches top mark on
dipstick. Reinstall vented dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below
bottom of plug hole, add recommended gear lube
through top dipstick hole until oil flows out of side plug
hole. Reinstall and tighten side oil plug (#2) and vented
dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox.
Wheel Support Busings & Wheel Bearings
Type of Lubrication: Multi-purpose Grease
35788
Bearing in Blade Spindle Hubs
Type of Lubrication: Multi-purpose Grease
35787
As
Required
25
Hours
25
Hours
4/03/14