Display Assembly - Dell Latitude C540 Service Manual

Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C540/C640 Service Manual
Back to Contents Page
Display Assembly, Display Latch, and
Hinge Covers
Dell™ Latitude™ C540/C640 Service Manual

Display Assembly

Display Latch
Hinge Covers
Display Assembly
NOTICE: You must remove the display assembly before you remove the palm rest.
NOTICE: Disconnect the computer and any attached devices from electrical outlets,
and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by
touching an unpainted metal surface on the computer.
NOTICE: Read
following procedureDisplay Assembly
1. Remove the
2. Remove the
3. Remove the keyboard.
4. Close the display.
5. From the back of the computer, remove the five M2.5 x 5-mm screws labeled "circle
D."
6. Open the display assembly approximately 180 degrees and support the display
assembly so that it does not open past this position.
7. Remove the two M2 x 3-mm screws on the EMI shield bracket, which is attached to
the display-feed flex cable.
file:///F|/Service%20Manuals/Dell/Latitude/c540-640/display.htm (1 of 12) [2/28/2004 7:57:51 AM]
"Preparing to Work Inside the
hard drive.
center control cover.
Computer" before performing the