Attaching an Adapter
The LDK 100 Camera head is a multi-role camera head
that can be used with various adapters. To attach an
adapter to the camera proceed as follow:
Caution
Be extremely careful with the connectors between
the camera head and the adapter. Do not allow the
guide pins to damage the pins of the connector.
Caution
Follow these steps in the order given. Tightening
the screws in the wrong order could result in
mechanical damage to the camera.
a. Using the rail
on the bottom of the camera head
1
as a guide, fit the guide pins
connector and the guide pin
camera head into the corresponding slots of the
adapter.
b. First, tighten the two horizontal screws
top of camera.
c. Next, tighten the two horizontal screws
front of the camera.
d. Lastly, tighten the vertical screw
the camera.
2
4
5
Installation
on either side of the
2
at the top rear of the
3
on the
4
at the
5
in the handle of
6
6
Technical Manual LDK 100 Camera Head
Detaching an Adapter
To detach an adapter from the camera head follow the
steps for attaching it in the reverse order.
Caution
Loosening the screws in the wrong order could
result in mechanical damage to the camera.
The procedure is given for the Triax adapter
LDK 5400. Follow the same procedure for the other
adapters.
3
1
Note
2-3