Table of Contents
Advertisement
13.
DUPLEX SWITCH: To program semi-duplex operation for channel 1 through chan-
nel8. Select the channel you would like to use as repeater channel (check your local
repeater station frequency first) and push the DUP switch and then DUP indicator will
turn on. Select next repeater channel and push the DUP switch again and so on. To
put the channel back to normal simplex operation, just select the DUPLEX pro-
grammed channel by channel selector and push the switch so that the DUP indicator
turns off to indicate that channel is no longer repeater frequency off-set channel. CH
1 through CH 8 are programmed for the repeater operation.
14.
CHANNEL SELECTOR SWITCH: This switch selects the desired channel for trans-
mission and reception.
.15
.16
.17
15.
EXTERNAL SPEAKER: The External Speaker Jack is used for remote receiver
monitoring.
The external speaker should have 8-ohm impedance and be rated to
handle at least 4.0 watts.
When the external speaker is plugged in, the internal
speaker is automatically disconnected.
16.
POWER: This jack permits connection of the D.C. power to the transceiver. A power
cord is supplied with the radio.
17.
ANTENNA CONNECTOR: This female connector permits connection of the trans-
mission line cable male connector (M-Type) to the transceiver.
MEMORY BACKUP
Channels maintained in the SUNDOWNER
UH-O11 memory are protected
from less by a built-in capacitor which protects
the memory
for up to
12 hours
when you disconnect
the DC Power
Cable.
5»
J
I
@r
@I
(
EX SP.
@
ANT
(
Hide quick links:
Advertisement
Table of Contents
