Sony HT-DDW8500 Operating Instructions Manual page 17

Installing the speakers on a flat
surface
Before you install the center speaker, surround
speakers, surround back speaker and
subwoofers, be sure to attach the supplied foot
pads to prevent vibration or movement as
shown in the illustration below.
Installing the speakers on the
wall
You can install your surround and surround
back speakers on the wall.
1
Prepare screws (not supplied)
that are suitable for the hook on
the back of each speaker as
shown in the illustrations
below.
more than 25 mm (1 inch)
4.6 mm
(3/16 inch)
10 mm
(13/32 inch)
Hook on the back of the speaker
4 mm (3/16 inch)
2
Fasten the screws to the wall.
The screws should protrude 5
to 7 mm (7/32 to 9/32 inch).
5 to 7 mm
(7/32 to 9/32 inch)
3
Hang the speakers on the
screws.
Hook on the back of the speaker
Notes
• Use screws that are suitable for the wall material
and strength. As a plaster board wall is especially
fragile, attach the screws securely to a beam and
fasten them to the wall. Install the speakers on a
vertical and flat wall where reinforcement is
applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
4.6 mm
(3/16 inch)
10 mm
(13/32 inch)
17 GB