Assembly And Adjustments; Operation - DeWalt DCR016-XE Instruction Manual

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury, turn the radio off and
disconnect the battery pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can cause injury.
To Install the Coin Cell Battery (Fig. 4)
WARNING: When replacing battery, replace it with the same brand and type.
Observe correct polarity (+ and –) when replacing batteries. Do not store or carry
batteries so that metal objects can contact exposed battery terminals.
Your radio is equipped with memory capacity
in order to store the time and your selected
memory channels. When the radio is OFF,
this memory capacity is powered by one
coin cell battery that is included with the
radio.
1. Turn the charger/radio off and unplug
from the power source.
2. Open the battery compartment by lifting
the battery compartment latch.
3. Unscrew the screw (O) on the battery door (L).
4. Press down on the battery door latch and pull to open.
5. Install the coin cell battery (M) according to the diagram inside the coin cell
battery area.
6. Replace the battery door, insert screw and tighten.
7. Securely close the battery compartment.
NOTE: To reset the LCD display, clock and presets, remove the coin cell battery and
re-install it. Follow this procedure if the screen seems to lock in place.

OPERATION

WARNING: Always observe the safety instructions and applicable regulations.
WARNING: Do not place the charger/radio in locations where it may be exposed to
dripping or splashing.
FIG. 3
O
M
L
6
Installing and Removing the Battery Pack (Fig. 4)
NOTE: To ensure maximum performance and life of Li-Ion batteries, charge the bat-
tery for a minimum of 10 hours before first use.
I
FIG. 4
1. Release the latch (I) to open the battery compartment cover.
2. Insert the battery pack (N) into the receptacle until it is fully seated.
3. Close and latch the battery compartment cover.
To remove the battery pack from the radio, press the release button and firmly pull the
battery pack out of the receptacle.
FUEL GAUGE BATTERY PACKS (FIG. 5)
Some D WALT battery packs include a
E
fuel gauge which consists of three green
LED lights that indicate the level of charge
remaining in the battery pack.
To actuate the fuel gauge, press and hold
the fuel gauge button (P). A combination
of the three green LED lights will illuminate
designating the level of charge left. When
the level of charge in the battery is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
N
FIG. 5
P