KitchenAid FREESTANDING OUTDOOR GRILL Installation Instructions And Use & Care Manual page 16

Change the Rotisserie/Infrared Burner Orifice
1. Using a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie/infrared burner wind baffle.
A. Wind baffle
2. Using a Phillips screwdriver, remove the 4 screws at the back
of grill from inside the grill (2 screws on each side of the
rotisserie infrared burner).
3. Remove the access cover at the back of the grill hood by
removing the 4 screws (2 screws on each side of the rotisserie
infrared burner).
A
A. Access cover
16
A
4. Using a Phillips screwdriver, remove the 2 screws holding the
spider guard to the burner.
5. Use 24 mm wrench to remove the orifice nut.
A. Orifice nut
6. Take out the orifice support, and then use a 6 mm socket and
wrench or 6 mm nut driver to remove the LP orifice at the end
of the supply pipe. Replace with Natural gas orifice.
B
A. Orifice support
B. Orifice
IMPORTANT: Check that the orifice is properly installed inside
of the supply pipe.
7. Reinstall the spider guard, access cover, and wind baffle.
A
A