Table of Contents
Advertisement
86(5)81&7,216
Speaker Phone Feature
If this feature has been programmed the ReadyGuard-REN is capable of operating as a speaker phone.
During speaker phone operation the system will provide the following functions:
•
All function/event processing will continue to operate, but there will be no announcements.
•
The ARMED (red) and READY (green) LEDs will alternately blink.
•
"PH" will be displayed.
NOTE: The system will enter the Speaker phone mode if an alarm or trouble is stored in the system memory. Although "PH" may
not appear, the LEDs will alternately blink indicating you are currently in the Speaker Phone mode.
!
Do not use the speaker phone as the only telephone in your home since in some special cases the
speaker phone is not functional.
The system will not enter speaker phone mode if:
•
The feature has not been programmed.
•
A report is being sent.
•
An audible alarm is present.
•
An announcement is being made or a recorded message is being played back.
•
A message is being recorded.
•
AC power is not present
The speaker phone will be aborted if:
•
A report must be sent.
•
An audible alarm or trouble has ocurred.
•
AC power is lost.
Using the Speaker Phone Feature
When the ReadyGuard-REN is operating in the speaker phone mode the system keypad functions as a
telephone keypad and the only security keypad functions that will remain enabled are the panic keys and the
speaker volume control. (refer to Volume Adjustment section) You may adjust the volume before entering
speaker phone mode or after dialing the desired number. In the speaker phone mode, if a zone is violated
and has triggered an entry/exit delay, the system will automatically change the keypad from telephone to
security mode. This allows the user to disarm the system or take other appropriate actions in the security
mode without interrupting the telephone session. To regain telephone keypad control (i.e.: to enter an
account number or menu selection) you will need to reactivate the telephone keypad as described below.
ReadyGuard-REN Speaker Phone Functions
To place a call using the Speaker Phone: [#] +
To answer a call using the Speaker Phone: [#] +
To flash (switch between two calls using call waiting):
To hang up:
OFF
To activate/deactivate (toggle) ringer: [#] +
To return the keypad to telephone mode after disarming the system: [#] +
NOTES: (1) The speaker phone ringer can only be enabled/disabled when the speaker phone mode is not active. The system will
ring once to confirm the ringer is enabled. Entering [#] +
ring will confirm that the ringer is disabled.
(2) The speaker phone ringer will not ring when an alarm, trouble or entry/exit delay are sounding.
(3) The ReadyGuard-REN speaker phone does not provide a "hold" feature
and dial the desired phone number
AUX
AUX
AUX
+
VOLUME
AUX
VOLUME
– 32 –
NOTE
If you are using pulse
(rotary) dialing, make
sure that ReadyGuard-
REN
has
dialing the last digit you
dialed, (listen to pulses)
before dialing the next
AUX
+
AUX
a second time will disable the ringer. No
finished
Advertisement
Table of Contents
