Sony Bravia KDL-52EX1 Operating Instructions Manual page 42

Intelligent Volume
Volume Offset
~
• Some options are not available when "Speaker" is set to "Audio System" or headphones are connected.
Screen
Wide Mode
Auto Wide
4:3 Default
Display Area
Horizontal Shift
Vertical Shift
Vertical Size
HDMI Set-up
This is used to set the "Control for HDMI" compatible equipment connected to the HDMI jacks.
Note that the interlock setting must also be made on the connected "Control for HDMI" compatible
equipment side.
Control for HDMI
Auto Devices Off
Auto TV On
Device List Update
HDMI Device List
42
GB
Keeps a constant volume level even when volume level gaps occur (e.g., adverts
tend to be louder than programmes).
Adjusts the volume level of the current input relative to other inputs.
See "To change the Wide Mode manually" on page 21.
Automatically changes "Wide Mode" according to the input signal. To keep your
setting, select "Off".
Selects the default Wide Mode for use with 4:3 broadcasts.
Wide Zoom Displays conventional 4:3 broadcasts with an imitation wide
screen effect.
Normal Displays conventional 4:3 broadcasts in the correct
proportions.
Off
Keeps the current "Wide Mode" setting when the channel or
input is changed.
Adjusts the picture display area in 1080i/p and 720p sources when "Wide Mode" is
set to "Full".
Full Pixel
Displays pictures in their original size if the input source is
1080i/p.
Normal Displays pictures in their recommended size.
-1/-2 Enlarges the picture to hide the edges of the picture.
Adjusts the horizontal position of the picture.
Adjusts the vertical position of the picture when "Wide Mode" is set to "Zoom".
Adjusts the vertical size of the picture when "Wide Mode" is set to "Wide Zoom"
or "Zoom".
This sets whether to interlock the "Control for HDMI" compatible equipment and
the unit. When set to "On", the following menu items can be performed. However,
power consumption in standby mode is higher than usual.
When this is set to "On", the "Control for HDMI" compatible equipment turns off
when you switch the unit to standby mode using the remote.
When this is set to "On" and if the connected HDMI, control compatible
equipment is turned on, the unit automatically turns on, and the displays the HDMI
input from the connected equipment.
Creates or updates the "HDMI Device List". Up to 14 "Control for HDMI"
compatible equipment can be connected, and up to four equipment can be
connected to a single jack. Be sure to update the "HDMI Device List" when you
change the "Control for HDMI" compatible equipment connections or settings.
Select them manually one by one until getting a correct picture for several seconds.
Displays the connected "Control for HDMI" compatible equipment.