Input Signal, Picture Mode And Display Status Information; Display Button - Sony PFM-42V1 Operating Instructions Manual

Input Signal, Picture Mode and
Display Status Information
Input signal and Picture Mode information appear on
the screen for about five seconds when the power is
turned on or when the input signal is switched.
To disable this function, follow the steps below.
1
In the Custom Setup menu, press M/m to move the
cursor (yellow) to "Display" and press ENTER or
,.
The following menu appears on the screen.
C u s t o m S e t u p
P o w e r S a v i n g :
S p e a k e r O u t :
C l o s e d C a p t i o n :
D i s p l a y :
S c r e e n S a v e r
C o l o r M a t r i x
H D M o d e :
R G B M o d e :
S y n c M o d e :
S e l e c t = S e t
2
Press M/m to set "Display" to "Off."
To display the information
Set "Display" to "On" in step 2 above. The factory
default setting is "On."
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.
S t a n d a r d
O n
O n
O f f
P C
H / C o m p
E n d
MENU
Watching the Picture
27
(GB)