Operation - DeWalt XR Li-ION DCS331-XE Instruction Manual

To attach no-mar shoe cover,
FIG. 9
place the front of the
aluminum shoe (G) into the
front of the no-mar shoe
cover (J) and lower the jig
saw. The no-mar shoe will
click securely onto the rear of
aluminum shoe.
To remove no-mar shoe
cover, grasp the no-mar
shoe cover from the bottom;
holding onto the two rear tabs
(M) remove the no-mar shoe cover.
ANTI-SPLINTER INSERT (FIG. 10)
NOTE: Do not use the anti-splinter
insert with the flush cutting blade.
The anti-splinter insert (N) should be
used when trying to minimize tear-
out, especially when cutting veneer,
laminate, or finished surfaces, such
as paint. The anti-splinter insert
should be installed into the no-mar
shoe cover (J). If the no-mar cover
is not used, install anti-splinter insert
into shoe (G).

OPERATION

WARNING: To reduce the risk of serious personal injury, depress the trigger
lock button and disconnect battery pack before making any adjustments or
removing/installing attachments or accessories. An accidental start-up can cause
injury.
Installing and Removing the Battery Pack (Fig. 11)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (B) into the tool handle, align the battery pack with the
G
M
J
FIG. 10
G
N J
rails inside the tool's handle and slide it into the handle until the battery pack is firmly
seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (A) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
FIG.11
FUEL GAUGE BATTERY PACKS (FIG. 12)
Some D WALT battery packs include a fuel gauge
E
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the
fuel gauge button (O). A combination of the three
green LED lights will illuminate designating the
level of charge left. When the level of charge in the
battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be
recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please call 1800 444 224
(Aust) or 0800 339 258 (NZ) or visit our website at www.dewalt.com.au or
www.dewalt.com.nz.
11
A
B
FIG.12
O