Table of Contents
Advertisement
Place the Bobbin in the Machine
Turn off the main switch
1. Make sure that the needle is fully raised
before inserting or removing the bobbin.
Open the bobbin cover by moving the
release button to the right (A). Remove
the cover (B).
2. Place the bobbin in the bobbin case
so that the thread is running in a
counterclockwise direction (C).
3. Pull the thread though the slit and pull
it to the left and along the inside of the
spring until it slips into the notch. Be sure
that the thread does not slip out of the
slit (D).
4. Pull out about 15cm (6 inches) of thread
and attach the bobbin cover plate (E).
Before sewing, raise the bobbin thread
(see page 20).
18
Hide quick links:
Advertisement
Table of Contents
