Connection - Panasonic WV-SP105 Installation Manual

Connection

Caution:
• FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.
Before starting the connection, turn off the power of this camera and the devices to be connected.
Check and prepare the required devices and cables for connection.
z
Connect a LAN cable (category 5 or better) to the
network connector on the rear of the camera.
x
Connect the power cord.
Important:
• The 12 V DC power supply shall be insulated from the commercial AC power.
When using 12 V DC power supply*
●
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm - 7 mm {1/8" to 9/32"} from the end of the
wire, and twist the stripped part of the wire sufficiently to
avoid short circuit.
Specification of cable (wire): 16 AWG - 28 AWG,
Single core, twisted
• Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug (accessory).
r Connect the power cord plug (accessory) to the 12 V DC
power supply terminal on the rear of the camera.
* FOR UL LISED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
12V IN
LAN cable
ACT
LINK
(This illustration
represents WV-SP105.)
12V IN
To 12 V DC
power supply
ACT
LINK
(This illustration
represents WV-SP105.)
12 V DC power
cord plug
(accessory)
(GND)
INITIAL
SET
POWER
INITIAL
SET
POWER
(12 V DC)
23