Code Label - Panasonic WV-SP105 Installation Manual

Cleaning this product body
Be sure to turn off the power before cleaning.
Do not use strong abrasive detergent when
cleaning this product. Otherwise, it may cause
discoloration.
When using a chemical cloth for cleaning, read
the caution provided with the chemical cloth
product.
When the dirt is hard to remove, use a
mild detergent and wipe gently.
When the dirt is hard to remove, use a mild
detergent and wipe gently. Then, wipe off the
remaining detergent with a dry cloth.
Transmission interval
Image transmission interval may become slow
depending on the network environment, PC
performance, shooting subject, access num-
ber, etc.

Code label

The code labels (accessory) are required at
inquiry for trouble. Use caution not to lose
these labels. It is recommended to paste one
of the labels onto the CD-ROM case.
Discoloration on the color filter of the
MOS image sensor
When continuously shooting a bright light
source such as a spotlight, the color filter of the
MOS image sensor may have deteriorated and
it may cause discoloration. Even when chang-
ing the fixed shooting direction after continu-
ously shooting a spotlight for a certain period,
the discoloration may remain.
AVC Patent Portfolio License
This product is licensed under the AVC Patent
Portfolio License for the personal and noncom-
mercial use of a consumer to (i) encode video
in compliance with the AVC Standard ("AVC
Video") and/or (ii) decode AVC Video that was
encoded by a consumer engaged in a personal
and non-commercial
12
activity and/or was
obtained from a video provider licensed to pro-
vide AVC Video. No license is granted or shall
be implied for any other use. Additional infor-
mation may be obtained from MPEG LA, LLC.
See http://www.mpegla.com.
Flickering
Due to the influence of lighting, flickering may
sometimes happen. In this case, select "Indoor
scene" for "Light control mode". Select "Indoor
scene(50Hz)" or "Indoor scene(60Hz)" in accor-
dance with the power supply frequency in your
locality. Refer to the Operating Instructions
(PDF) for further information about the setting.
Under extremely strong lighting, flickering may
happen even when "Indoor scene" is selected
for "Light control mode".
When the brightness (illuminance) level on the
screen is set to a relatively low level with the
[Brightness] buttons, flickering may frequently
happen. In such cases, either of the following
can reduce flickering.
• Moderate the illumination intensities of
objects by changing the camera direction.
• Set the brightness (illuminance) level on the
screen to a brighter level with the
[Brightness] buttons.
White-out on images caused by the effect
of light control mode
When "Indoor scene" is selected for "Light con-
trol mode", the tone of the brighter parts on the
screen may be deteriorated than the case
when "ELC" is selected.
Color blurring on detailed drawing pat-
terns
When there are detailed drawing patterns on
images, color blurring may happen over these
parts.
White dot noise
When the brightness levels of objects are too
low, white dot noise may appear on the screen.