Chamberlain Security+ 3290 Owner's Manual page 22

ALL ONE-PIECE DOORS
1. Assemble the Door Arm:
IMPORTANT: The groove on the straight door arm MUST face
away from the curved door arm (Figure 5).
• Fasten the straight and curved door arm sections together to
the longest possible length (with a 2 or 3 hole overlap).
• Make sure the garage door is fully closed. Connect the
straight door arm section to the door bracket with the
5/16"x1-1/4" clevis pin.
• Secure with a ring fastener.
• Pull the emergency release handle, disconnecting the outer
trolley from the inner trolley by pulling straight down on the
emergency release handle and sliding the outer trolley back
toward the motor unit.
• Connect the curved door arm section to the trolley using the
5/16"x1-1/4" clevis pin and ring fastener.
NOTE: Adjusting the limits on the following page:
• The trolley will automatically connect. If not, review the
trolley lockout feature on page 27.
• When setting the up limit on the following page, the door
should not have a "backward" slant when fully open as
illustrated below. A slight backward slant will cause
unnecessary bucking and/or jerking operation as the door is
being opened or closed from the fully open position.
Figure 6
Inner Trolley
Outer Trolley
Door Arm
Connector Hole
Door Arm
Closed
Door
Inner Trolley
Correct Angle
Open Door
Figure 5
CORRECT
Straight
Door Arm
(Groove
facing out)
Door
Bracket
Clevis Pin
Straight
5/16"x1-1/4"
Arm
Bolts
5/16"-18x7/8
Emergency Release Handle
Door Arm
Door with
Backward Slant (Incorrect)
22
INCORRECT
Straight
Door Arm
Curved
Door
Curved
Arm
Door
Arm
Ring
Fastener
Nuts
Lock
5/16"-18
Washers
5/16"
Outer Trolley
Curved
Door Arm