Table of Contents
Advertisement
STEP 2
Enrolling and Removing KeyFobs
Each KeyFob must be enrolled into the receiver. The following procedure is used to enroll the unique RF ID number
stored in the non-volatile memory of each KeyFob into the receiver memory.
Arm system from any keypad
1
Disarm system from any keypad
2
D
3
Press 1114
on keypad
4
Press the ∗ button on KeyFob 1
....
Repeat for each KeyFob to be enrolled
Press
on Keypad
C
• The Keyfob Enroll Mode may also be entered / exited by pressing the the Enroll Mode Push Button on the top of the
receiver. See page 18 for more information.
• To Remove a lost KeyFob from the system: Enter and then exit the Keyfob Enroll Mode (Arm and disarm the
D
system, enter 1114
For NAPCO "K Series" Keypads, see pages 10 and 13.
For Ademco Keypads, see pages 11 and 14
- ENROLLING KEYFOBS--With NAPCO "Classic" Keypads
and then press
C
). All keyfobs will be deleted from the system.
www.BevanSecurity.Com
The Enroll Mode LED will flash rapidly.
The keypad will give error beeps - ignore.
The KeyFob will sound a single confirmation beep.
Exit Enroll Mode - the Enroll Mode LED will start to slowly pulse.
The KeyFob will give a series of beeps and the unlock icon will
display.
NAPCO "Classic" Keypads
GEM-RP1CAe2, GEM-RP2ASe2,
GEM-RP3DGTL
NAPCO "K Series" Keypads
GEM-K1CA, GEM-K2AS,
GEM-K3DGTL, GEM-K4RF
9
Advertisement
Table of Contents
