Table of Contents
Advertisement
Getting to Know Your Canyon
14
Rear Seat Folding Operation
(if equipped)
Fold down the forward-facing rear
seat on Extended Cab models
• Pull down on the bottom of the seat
until it is in place.
Note: The rear seat storage compart-
ments must be in the rearward position
before folding the seat down.
Store the seat
• Push the entire seat up until it is flush
with the trim panel.
Note: To ensure that the hinges or
latches do not damage the safety belt or
cause the belt buckle to rattle, fold and
store the belt between the seat cushion
and seatback using the Velcro attach-
ments provided on the lower portion of
the seat.
Fold the Crew Cab's rear seatbacks
forward
1. Insert a small-tipped tool into the slot
to unlatch the center safety belt
buckle and move the belt to the side,
out of the way.
2. Grasp the loop located on the side of
the seatback (A) and pull it until you
hear a click.
A
3. Fold the seatback down.
Repeat the process to fold the other
seatback.
Return the Crew Cab's rear seatbacks
to the upright position
1. Lift the seatback up and push it into
place.
2. Reconnect the center safety belt latch
plate with the buckle.
3. Push and pull on the seatback to
ensure that it is secured.
Repeat these steps for the other seat-
back as necessary.
See Section 1 of your Owner Manual.
Flexible Tailgate
The tailgate features a flexible design
that allows it to be positioned fully
up, fully down, removed, or partially
lowered.
Remove the
tailgate
1. With the
tailgate fully
open, lift it
up slightly.
2. Remove the
retaining
cable from
each side of the tailgate by pulling the
clip away from the bolt head while
pushing the cable bracket forward.
When the larger part of the hole on
the bracket is over the bolt, slide the
bracket off.
3. With the tailgate partially down, lift up
on the passenger's side and pull the
tailgate toward you; then move the
tailgate to the right to release the driv-
er's side. Remove the entire tailgate.
Advertisement
Table of Contents
