Pioneer DXT-X2669UI Owner's Manual page 13

Installation
DIN Front-mount
1 Insert the mounting sleeve into the dash-
board.
For installation in shallow spaces, use the sup-
plied mounting sleeve. If there is enough space,
use the mounting sleeve that came with the ve-
hicle.
2 Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°) into
place.
1
2
1 Dashboard
2 Mounting sleeve
# Make sure that the unit is installed securely in
place. An unstable installation may cause skipping
or other malfunctions.
DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracket and the side
of the unit match.
2 Tighten two screws on each side.
3
1
2
1 Screw
2 Mounting bracket
3 Dashboard or console
! Use either truss (5 mm × 8 mm) or flush sur-
face (5 mm × 9 mm) screws, depending on
the bracket screw holes.
Removing the unit
1 Remove the trim ring.
1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-
cess to the trim ring.
! When reattaching the trim ring, point the
side with the notched tab down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
Installation
3 Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
For details, refer to Removing the front panel and
Re-attaching the front panel on page 4.
Securing the front panel
The front panel can be secured with the sup-
plied screw.
1
1 Screw
Speaker installation
16 cm 2-way speakers
D
E
A A
F
G H I
B C
Front
A 45°
B f 4.3 mm holes (3/16 in. Dia.)
C f 142 mm (5-5/8 in. Dia.)
D 123 mm (4-7/8 in.)
E 113 mm (4-1/2 in.)
F 100 mm (3-7/8 in.)
G 123 mm (4-7/8 in.)
H 100 mm (3-7/8 in.)
I 113 mm (4-1/2 in.)
A B
C D E F
G
Side
A 13 mm (1/2 in.)
B 41 mm (1-5/8 in.)
C f 65 mm (2-5/8 in. Dia.)
D f 128 mm (5 in. Dia.)
E f 158 mm (6-1/4 in. Dia.)
F f 170 mm (6-3/4 in. Dia.)
G 27 mm (1 in.)
1 Determine the location of the speaker as
illustrated.
Section
03
13
En