Front Glass Enclosure Panel, Removal And Installation - Lennox EBVSTNM-B Care And Operation Instructions Manual

Front Glass Enclosure Panel, Removal
and Installation
WARNING
• Do not attempt to substitute
the materials used on this door,
or replace cracked or broken
glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as a
complete unit as provided by the
manufacturer. Do not attempt
to replace broken, cracked or
chipped glass separately.
• Do not attempt to touch the front
enclosure glass with your hands
while the fireplace is in use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
12
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
WARNING: DO NOT abuse glass door by
striking or slamming shut.
These are B-vent appliances. They are designed
to operate only when the glass enclosure panels
are installed. Generally the glass enclosure panels
should not be removed except to gain access to
the components within the firebox.
Removing Glass Enclosure Panels
(see Figure 6)
Remove the top louver assembly or radiant
panel.
To access the glass door securing latch, first
open the lower control compartment door
(Figure 6) by pushing in simultaneously the left
and right top corners of the door. (The door is
hinged at the bottom).
Remove the bottom compartment door by
sliding the hinge pin, located at the door's left
side, to the right until it disengages from the
left corner post hole. Pull the door diagonally
to the left, away from the fireplace.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Locate the latch at the top of the control com-
partment and disengage them from the door
frame bottom vee-flange, pulling down on its
handle to open it.
Installing Glass Enclosure Panel
(see Figure 6)
Retrieve the glass door. Visually inspect the
gasket on the backside of the frame. Gasket
surface must be clean, free of irregularities
and seated firmly.
Position the door in front of the firebox opening
with the bottom of the door held away from the
fireplace (Figure 6). Hook the top flange of the
door frame over the top of the firebox frame.
Let the bottom of the door frame swing gently
in towards the fireplace ensuring that the gasket
seats evenly as the door frame draws shut.
Fasten the latch located underneath the firebox
floor to the door's vee-flange. Close both the
latch securely.
Control Compartment Access Panel and Hinge
Top Flange
Glass Door Frame
Glass
Door Latch
Bottom Vee-flange
Glass Door Frame
Firebox Floor
NOTE: When installing the glass door, ensure the
spacing on both sides is even and equal.
Figure 6 EBVST SHOWN
Front Glass
Enclosure Panel