Cisco BR1400 Deployment Manual page 13

VLAN 12
Station_B
Station_C
VLAN 14
Infrastructure ssid: native VLAN
VLAN CONFIGURATION
Figure 8.
The main steps to configure the VLANs are:
1) Enable 802.1q trunking on the wired network: On either side of the Link you should console into
the Ethernet port of the Switch to which Bridge is connected and give the following commands:
Interface FastEthernet0/1
Switchport trunk encapsulation dot1q
Switchport mode trunk
Please note that you must have 100 Mbps Ethernet connections between the switch and
the Bridge.
2) Enable 802.1q trunking on the Bridges: Specify the VLAN-id X as the native VLAN on the
root and non root bridges by going into the GUI services and clicking on VLAN.
Copyright © 2004 Cisco Systems, Inc. All rights reserved.
Station_A
VLAN 11
Root
Switch_1
802.1Q Trunk
100Mbps,
NATIVE VLAN
Page 13 of 53
VLAN 11
Non-Root
Switch_2
Station_E
VLAN 12
Station_
D