D-Link xStack DGS-3400 Series Cli Reference Manual page 434

xStack
delete rspan vlan
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an RSPAN VLAN entry by VLAN name "v2":
DGS-3450:admin# delete rspan vlan vlan_name v2
Command: delete rspan vlan vlan_name v2
Success.
DGS-3450:admin#
To delete an RSPAN VLAN entry by VLAN ID "3":
DGS-3450:admin# delete rspan vlan vlan_id 3
Command: delete rspan vlan vlan_id 3
Success.
DGS-3450:admin#
config rspan vlan source
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
delete rspan vlan [vlan_name <vlan_name> | vlan_id <value 1-4094>]
This command is used to delete RSPAN VLANs.
vlan_name - Delete RSPAN VLAN by VLAN name.
vlan_id - Delete RSPAN VLAN by VLAN ID.
Only Administrator and Operator-level users can issue this command.
Used by the source switch to configure the source setting for the RSPAN VLAN.
config rspan vlan [vlan_name <vlan_name> | vlan_id < vlanid 1-4094>] source { [
mirror_group_id <value 1-4> | [add | delete] ports <portlist> [rx | tx | both]]}
This command configures the source setting for the RSPAN VLAN on the source switch.
vlan - See below:
vlan_name - Specify the RSPAN VLAN by VLAN name.
vlan_id - Specify the RSPAN VLAN by VLAN ID.
source - If the ports are not specified by this command, the source of RSPAN will come from
the source specified by the mirror command or the flow-based source specified by an ACL.
If no parameter is specified for source, it deletes the configured source parameters.
add - Add source ports.
delete - Delete source ports.
ports <portlist> - Specify source portlist to add to or delete from the RSPAN source
rx - Only monitor ingress packets.
tx - Only monitor egress packets.
both - Monitor both ingress and egress packets.
mirror_group_id - The mirror group identify that specify which mirror session used for RSPAN
source function.
If the mirror group is not specified when configuring the mirror ports, the mirror group 1 will be
the default group.
Only Administrator and Operator-level users can issue this command.
430