D-Link xStack DGS-3400 Series Cli Reference Manual page 205

xStack
delete erps raps_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an ERPS R-APS VLAN:
DGS-3450:admin# delete erps raps_vlan 4094
Command: delete erps raps_vlan 4094
Success.
DGS-3450:admin#
config erps ring_mel
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a MEL of the ERPS ring:
DGS-3450:admin# config erps raps_vlan 4094 ring mel 2
Command: config erps raps_vlan 4094 ring mel 2
Success.
DGS-3450:admin#
config erps raps_vlan ring_port
Purpose
Syntax
Description
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to delete an R-APS VLAN on a switch.
delete erps raps_vlan <vlanid>
This command is used to delete an R-APS VLAN on a switch. When an R-APS VLAN is
deleted, all parameters related to this R-APS VLAN will also be deleted.
This command can only be issued when the ring is not active.
raps_vlan - Specifies the VLAN which will be the R-APS VLAN.
Only Administrator and Operator-level users can issue this command.
Used to configure the MEL of the ERPS ring for a specific R-APS VLAN.
config erps raps_vlan <vlanid> ring mel <value 0-7>
This command is used to configure the ring MEL for a R-APS VLAN. The ring MEL is one
field in the R-APS PDU.
Note: If CFM (Connectivity Fault Management) and ERPS are used at the same time, the R-
APS PDU is one of a suite of Ethernet OAM PDU. The behavior for forwarding of R-APS
PDU should follow the Ethernet OAM. If the MEL of R-APS PDU is not higher than the level
of the MEP with the same VLAN on the ring ports, the R-APS PDU cannot be forwarded on
the ring.
ring mel - Specifies the ring MEL of the R-APS function. The default ring MEL is 1.
Only Administrator and Operator-level users can issue this command.
Used to configure the ports of the ERPS ring for a specific R-APS VLAN.
config erps raps_vlan <vlanid> ring_port [west [<port> | virtual_channel] | east [<port>
| virtual_channel]]
This command is used to configure the port that participates in the ERPS ring. Restrictions
apply for ports that are included in a link aggregation group. A link aggregation group can be
201