Table of Contents
Advertisement
1. After you have completed the setup process, the operating system installation
2. The ServerGuide program stores information about the server model, service
3. With some operating system installations, you can create an operating system
4. The ServerGuide program presents operating system partition options that are
5. If you are installing the operating system from diskette, the ServerGuide
6. The ServerGuide program prompts you to insert your operating system CD and
Setting up or updating multiple servers
You can use the ServerGuide program to create diskettes that help you set up or
update multiple servers. You can modify information on the diskettes as you use
them to set up or update other servers.
Note: Availability and function can vary by server model and by the hardware that
You can create a setup-replication diskette, which contains your hardware
configuration selections. Use this diskette to replicate selections to other servers
that are of the same model.
You can create a operating system replication diskette, which contains information
that you need to complete multiple installations. Not all operating systems support
operating system replication diskettes.
Installing your operating system without ServerGuide
If you have already configured the server hardware and you decide not to use the
ServerGuide program to install your operating system, complete the following steps
to download the latest operating system installation instructions from the IBM
Support Web page:
1. Go to http://www.ibm.com/pc/support/.
2. Under Browse, click Servers.
3. From the Family drop-down list, select your server model.
4. If operating system installation instructions are available for your server model,
program starts. (You will need your operating system CD to complete the
installation.)
processor, hard disk drive controllers, and network adapters. Then, the program
checks the CD for newer device drivers. This information is stored and then
passed to the operating system installation program.
replication diskette for setting up additional servers. This diskette contains the
Internet protocol (IP) address, server name, and other selections.
based on your operating system selection and the installed hard disk drives.
program lists the diskettes that you must create and the optional diskettes that
you might want to create. The diskettes that you can create are the
device-driver diskettes for the installed adapters or controllers.
restart the server. At this point, the installation program for the operating system
takes control to complete the installation.
is installed.
OS installation is in the list in the upper-left corner of the Web page. Click OS
installation and select the instructions for your operating system.
21
Chapter 2. Configuration
Advertisement
Table of Contents
