Table of Contents
Advertisement
PURGES
Automatic Purge
With all functions off either, manually or by program, a
60 minute timer will be initiated. Once this timer is fin-
ished, a 1 minute purge will be activated (blower) to
purge any remaining water in the air channel. If any
key is pressed the purge timer will be reset.
Daily Purge
If the user holds the button on the bath control on the
unit for 5 seconds, the program will initiate a 1 minute
purge (start the blower) and will purge every day at the
same time for 1 minute. To cancel the daily purge op-
tion simply hold the button for 5 seconds. The daily
purge will not activate if one of the accessaries is on,
but it will have priority on the Automatic purge. This
means that if the program is waiting to Automatic purge
and a Daily purge crosses that time, then the automatic
purge will be cancelled and the daily purge will be
initiated.
BATH CONTROL
CD/DVD FUNCTION (VIDEO INPUTS TO TV)
1. Press TV button, then POWER Button. This will turn
the TV ON.
2. Press CD/DVD to select the applicable input source.
The on-screen display will show VIDEO 1 or VIDEO
2 for any external video components or TV mode.
CD PLAYER/AM/FM SYSTEM
Power On
The CD player and AM/FM system must be activated
from the manufacturers remote control for the CD unit
or manually from the CD player panel. The floating re-
mote does not control CD/AM/FM functions.
AUX-IN Setup
In order to hear the TV audio, CD Player/AM/FM Sys-
tem must be set to AUX-In mode. To perform this set-
ting, follow the instructions of the CD Receiver manual
under AUX IN Mode. If power to the unit is interrupted,
the CD Receiver will have to be reset.
For complete operation of the CD/AM/FM unit consult
the manual enclosed.
Note: The manufacturers remote for the CD/AM/FM unit
is not intended to be used in the bath.
Note: The quality of AM reception will vary by locality.
Jacuzzi Whirlpool Bath is not responsible for the quality
of AM reception.
TV
The Floating Remote will control the volume and change
the channels of the TV.
For complete operation of the TV consult the manual
enclosed.
Note: The TV manufacturer's remote is not intended to
be used in the bath.
REMOTE BATTERY REPLACEMENT
The remote is powered by 2 AAA size batteries. To
change the batteries, unscrew and remove the rear
cover. Remove the old batteries and load the new ones
with their polarities (+ and –) aligned properly. Replace
the cover making sure the water proof gasket (screws
and control) is in the proper position.
After the batteries have been replaced, the LED will flash
twice to indicate that the programmed codes are still
memorized. The LED will flash 3 times to indicate the
programmed codes have been erased and will have to
be reprogrammed. You have 3 minutes to change the
batteries before the codes will be erased.
NOTE: Batteries installed with incorrect polarity may
leak and damage the remote control. Do not mix old
and new batteries or carbon types with alkaline types.
BATTERIES (2 AAA)
REAR SIDE
COVER
SUGGESTED LOCATION FOR REMOTE HOLDER
Apply a dab of clear silicone adhesive to the under-
side of holder and attach where convenient in area
shown.
AREA TO LOCATE
REMOTE HOLDER
10
COVER REMOVED
Advertisement
Table of Contents
