DeWalt D26414 Instruction Manual page 30

Voltage (Volts)
Total length of cord in meters (m)
120–127V 0–7
220–240V 0–15
Rated Ampere Minimal cross-sectional area of the
range
0–6A 1.0
6–10A 1.0
10–12A 1.5
12–16A 2.5
WARNING: Do not use in explosive atmosphere
WARNING: Do not let tool unattended while it is in use.
WARNING: The equipment is not intended for use by persons
(including children) with reduced physical, sensory or mental
capabilities reduced or no experience or knowledge, unless they are
supervised or instructed in its use by a person responsible for their
safety.
WARNING: Children will be supervised to assure they do not play
with the tool.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
7–15 15–30 30–50
15–30 30–60 60–100
cord in meters (mm 2 )
1.5 1.5 2.5
1.5 2.5 4.0
1.5 2.5 4.0
4.0 Not Recommended
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALL USERS AND BYSTANDERS MUST
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... revolutions per minute ....................... speed
BPM ............. beats per minute
IPM ............... impacts per minute
28
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
n ......................rated
........................speed