Installation Instructions - COZY BBT53 Installation And Operating Instructions Manual

INSTALLATION INSTRUCTIONS

WARNING: If the information in these instructions are not followed exactly, poor performance, fire or
explosion may result causing property damage, personal injury or loss of life.
This kit was designed and certified for use with a Cozy Gas Baseboard Heater only. Use only factory supplied
parts. Do not alter kit.
WARNING: DO NOT INSTALL IN WINDOW WELL OR BELOW GRADE WHERE WATER MAY
ACCUMULATE. BOTTOM OF VENT RISER KIT MUST NOT TOUCH THE GROUND.
SPECIAL PRECAUTIONS MUST BE TAKEN TO PREVENT SNOW BUILD-UP OVER
KIT.
STEP 1. Install Cozy gas baseboard heater per installation instructions.
STEP 2. Verify air intake tube extends 1-1/2" past surface of outside wall and the vent exhaust tube
extends 2-1/2" past surface of outside wall. See Figure 1.
STEP 3. Slide the Vent Riser Kit over the intake and exhaust tubes and back flush against wall. NOTE:
Louvered section of kit must be up. See Figure 2.
STEP 4. Mark and drill six (6) mounting holes in wall matching six (6) holes in flange on the Vent Riser
Kit. Depending on wall material, anchors (not provided) may be required. See Figure 2.
STEP 5. Secure Vent Riser Kit to wall. See Figure 2.
WALL
VRK5/10 VENT RISER KIT
1-1/2"
2-1/2"
FIGURE 1
Louvered end must
be up
AIR INTAKE
TUBE
VENT
EXHAUST
TUBE
Mounting
Holes
Page 16
Vent Riser Kit
installed
FIGURE 2