Table of Contents
Advertisement
L.
Lower guide rod and secure lower snap ring. Repeat
steps 6J - 6L for the other guide rod.
7. Belt Routing.
A.
Verify belt is routed through top of pulley bracket and
then route end of belt down to the top weight.
B.
Carefully lift top weight and verify that the position of
the belt clamp (on the top weight) is aligned properly
with the top pulley bracket (on the machine). See
Figure 10.
C.
Slide belt through slot in belt clamp.
D.
Verify belt and insert are installed properly, as shown in
Figure 11A. NOTE: Do not install the insert backwards as
shown in Figure 11B.
E.
Pull belt tight and secure belt to clamp with the two
set screws. See Figure 12. NOTE: Torque set screws
300-350 in./lbs.
F.
Place weight stack pin in each plate to verify proper
installation.
G.
Without selecting any resistance, lift top weight
up and down (simulating normal operation).
H.
Have an assistant verify that the belt is moving smoothly and is
routed straight from the top pulley bracket to the
to weight belt clamp.
I.
Reinstall the six increment weights that were removed
in step 6B. See Figure 13.
J.
Turn the Increment Weight Adjusting Knob to select all
15 lbs.
Assembly
Page 4-4
Cybex Eagle 11000 Chest Press Owner's Manual
Insert and Set Screws (not
shown) are on this side.
Belt
Increment
Weight
Adjusting
Knob
Figure 10 (top view from pulley down to belt clamp)
Correct belt routing
Insert
Belt
Stem
Figure 11A
Belt clamp
insert
Set screws
Figure 12
Grooves
Increment Weights
Figure 13
Top Pulley
Wrong belt routing
Insert
Stem
Figure 11B
Belt
Belt clamp
Belt
Advertisement
Table of Contents
