Fireplace Installation - Dimplex PF2325 Owner's Manual

Fireplace Installation

WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: To reduce the risk
of fire, do not store or use gaso-
line or other flammable vapors or
liquids in the vicinity of the heater.
CAUTION:
circulation beneath the fire-
place insert is provided by 4
felt feet.
Do not install the fireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION:
6
Clearance for air
If installing the
fireplace in a carpeted area, place
a one-piece, solid, flat surface un-
der the fireplace. Ensure that all
feet rest securely on this surface.
!
NOTE: The dimensions of the
firebox are:
Width
24.1in.
PF2325
(612mm)
31.3in.
PF3033
(796mm)
Mantel Installation
Install the fireplace into the
mantel (refer to mantel assembly
instructions).
!
IMPORTANT: Install the man-
tel so that it is a minimum of ¼ in.
(6 mm) off of the wall to ensure
adequate air flow.
!
IMPORTANT: If not using a
Dimplex mantel, the fireplace
must be installed in an enclosure
with the following minimum inter-
nal/opening dimensions - Figure
1.
Height Depth
18.1in. 8.9in.
(459mm) (226mm)
22.5in. 8.9in.
(572mm) (226mm)
www.dimplex.com