Sony DCR-PC115E Operating Instructions Manual page 116

Inserting a scene from a VCR
– Insert editing
4
ZERO SET
MEMORY
To change the insert end point
Press ZERO SET MEMORY again after step 5 to
erase the ZERO SET MEMORY indicator and
begin from step 3.
Using the Remote Commander
In step 5, press z REC and MARK
simultaneously, then immediately press X. And
in step 6, press X at the scene where you want to
start recording from.
Note
The picture and sound recorded on the portion
between the insert start and end points will be
erased when you insert the new scene.
If you insert scenes on the tape recorded with
other camcorder (including other DCR-PC115E/
PC120E)
The picture and sound may be distorted. We
recommend that you insert scenes on a tape
recorded with your camcorder.
When the inserted picture is played back
The picture and sound may be distorted at the
end of the inserted portion. This is not a
malfunction.
The picture and sound at the start point and the
end point may be distorted in the LP mode.
To insert a scene without setting the insert
end point
Skip steps 3 and 4. Press x when you want to
stop inserting.
116
0:00:00
ZERO SET
MEMORY
5
X
x
REC
z
X