22
BASIC OPERATIONS
EN
Still Image Recording
MODE
Power Switch
1
Set the power switch to
lock button located on the switch.
2
Press MODE to select
● The camera is programmed to record still images on the
medium in the CF slot by the factory preset. To switch the
recording medium, see pages 26 and 27.
● To change the image size and picture quality, see pages 26
and 29.
3
Press the recording start/stop button. The still image is
recorded.
● To check how the image looks before recording, press the
recording start/stop button halfway and hold. The
indicator appears and stops blinking when the captured
image is focused. To cancel the recording, release the
recording start/stop button. To record it on the recording
medium, press the recording start/stop button fully.
Recording Start/Stop Button
Lock Button
while pressing down the
.
NOTES:
● There may be differences in the brightness between the
recorded video and still image, even if the same subject is
shot.
● To turn the shutter sound off, see page 26.
● For approximate number of storable images, see page 42.
Continuous Shooting
Keeping the recording start/stop button pressed in step 3
provides an effect similar to serial photography. (Interval
between still images: approx. 0.3 seconds)
To use this function, set [CONTINUOUS SHOOTING] to
[ON]. (
pg. 26, 29)
● Continuous shooting may not work well depending on
the recording medium.
Deleting Files
If you press
during recording mode, the file recorded
most recently will be deleted.
● However, if the recording mode (video, still image or voice) is
switched or the power is turned off and on again after
recording, you cannot delete the file.