Table of Contents
Advertisement
4.6 In-Circuit-Programming Connector (X4)
There is a flash-programming socket on the starter-kit, which makes it possible to program
the flash MCU with a special programming adapter. Mode pin MD0 and reset signal are also
available at this connector.
Pin Number
Pin Signal
1
2
3
DEBUG I/F
4
5
RSTX
6
7
SOT2
8
SCK2
9
10
4.7 Debug Connector (X12)
The MB96600 microcontroller series facilitates on-chip debugging via a single-wire
system with the embedded emulator MB2100-01-E. The emulator is connected to
the starter kit via SMA jack.
4.8 Alarm Comparator Connector (J2)
On the Connector J2 the adjusted analog voltage of potentiometer RP2 can be measured.
This voltage is used for the alarm comparator ALARM0 or analogue input AN8 on pin 26.
4.9 External Supply Voltage Vin (J3)
This connector is connected to the external supply voltage (Vin).
© Fujitsu Semiconductor Europe GmbH
Change odd page title here
Chapter 4 Connectors
Figure 4-5: In-circuit programming connector
Description
NC
Not used
NC
Not used
MCU mode/debug pin DEBUG I/F
NC
Not used
MCU reset signal
SIN2
UART2 receive data
UART2 transmit data
UART2 clock
VCC
Board supply voltage
GND
Ground
Table 4-4: In-circuit programming connector
Figure 4-6: Debug Connector
- 29 -
FMEMCU-UG-960031-13
Advertisement
Table of Contents
