JVC KD-X250BT Instruction Manual page 12

Bluetooth connection
Pairing a Bluetooth device
When connecting a Bluetooth device to the unit for the first time, perform pairing between the unit and
the device.
Up to five Bluetooth devices can be registered in this unit.
A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
This unit supports Secure Simple Pairing (SSP).
1 Search and select "JVC UNIT" on the Bluetooth device.
"BT PAIRING" flashes on the display.
For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN) code
immediately after searching.
2 Perform (A) or (B) depending on what scrolls on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below
(A) If "[Device Name]" "XXXXXX"
"VOL – YES" "BACK – NO" scrolls on the
display,
"XXXXXX" is a 6-digit passkey randomly
generated during each pairing.
Ensure that the passkey which appears
on the unit and Bluetooth device is the
same.
Select "YES" to confirm the passkey.
Operate the Bluetooth device to confirm
the passkey.
After pairing is successful, "PAIRING COMPLETED" appears on the display.
The unit will establish a connection with the newly paired Bluetooth device, " " lights up on the
display and you can now control the Bluetooth device through the unit.
" " will light up when a phone is connected.
" " will light up when an audio device is connected.
Once the connection is established, the device is registered to the unit and there is no need to
perform the pairing again unless you delete the registered device.
Some Bluetooth devices may not be able to connect to the unit after pairing. Connect the device to
the unit manually. Refer to the instruction manual of the Bluetooth device for more information.
See page 13 for Bluetooth compatibility check mode operation.
12 | ENGLISH
(B) If "[Device Name]" "VOL – YES"
"BACK – NO" scrolls on the display,
Select "YES" to start the pairing.
(1) If "PAIRING" "PIN 0000" scrolls on the
display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before
pairing. ( page 22)
(2) If only "PAIRING" appears, operate the
Bluetooth device to confirm pairing.