Operating Modes - Bounty Hunter Land Ranger Pro Owenrs Manual

OPERATING MODES

C
DISC
This preset mode is configured for coin-hunting.
Iron, foil and aluminum are not detected.
Tones are: Low - zinc
Medium - U.S. Nickels
High - 10¢, 25¢, 50¢, $1 and silver
Sensitivity and Volume settings can be adjusted. The Ground setting is preset
to 82 and cannot be adjusted.
J
DISC
This preset mode is configured for jewelry-hunting.
Iron is not detected.
Tones are: Medium - most gold and small silver
High - silver
Sensitivity and Volume settings can be adjusted. The Ground setting is preset
to 82 and cannot be adjusted.
A
DISC
This preset mode is configured to hunt for artifacts.
Small iron objects are not detected.
Large iron objects are detected.
Tones are: Low - iron
Medium - foil, nickels, aluminum, zinc and most gold
High - copper and silver
Sensitivity and Volume settings can be adjusted. The Ground setting is preset
to 82 and cannot be adjusted.
2 3
,
and
DISC
Ground controls. Select your preferred mode depending on the number of
tones you want to hear.
2
(two tones)
DISC
Tones available are low and V.C.O. The V-Break
of Target-IDs that induce low tones. The factory default V-Break
unless adjusted, all iron will induce low tones.
3
(three tones)
DISC
This mode is the same as DISC
conductive targets.
4
(four tones)
DISC
This mode is the same as DISC
conductive targets and a medium tone for nickels.
ALL METAL
This mode does not allow for rejection of any targets. Many treasure hunters
prefer All Metal when hunting ground with little trash metal present.
Audio is V.C.O. for all targets.
4
can be used with the V-Break
®
2
, with the addition of a high tone for highly
2
, with the addition of a high tone for highly
® , Disc Level, Notch and
setting determines the range
® setting is 19;
17