Initial Setting; Basic Setting; G-50A Unit Setting; Network Setting - Mitsubishi Electric G-50A Operation Manual

5 Initial Setting

Given below is an explanation on how to set each type initial setting such as the G-50A main unit settings and
group setting.

5-1 Basic Setting

Display the page needed to perform the G-50A basic setting by clicking [Initial Setting]-[Basic Setting] in the
setting menu pane. On this page, you perform the basic setting such as the G-50A unit name, network setting
and M-NET setting.
Click [Get from G-50A] to get data that is currently held by the G-50A unit, or click [Set to G-50A] to send setting
data to the G-50A. After the basic setting content is sent to the G-50A, a message will appear asking whether or
not to restart the G-50A. If you want the new setting content such as IP address to be immediately mirrored, then
restart the G-50A as directed by the message.
Note: When restarting the G-50A, there will be a 2-3 minute delay before communication can be reestablished.

5-1-1 G-50A Unit Setting

In Unit Setting, set the G-50A name and unit ID.
(1) Enter the G-50A unit name in the [Name] field. You may enter a maximum of 40 alphanumeric or symbol
characters. The name set here is used on the display screen of the software that controls multiple G-50A
units and for the name of the sender in the body of error messages.
Note: The following characters cannot be used in the name: < > & " '
(2) Enter the G-50A unit ID in the [Unit ID] field. You must enter 6 numeric characters. Use this setting when you
want to control multiple G-50A units with unit IDs. The unit ID that is entered here will be used on the display
screen of the software that controls multiple G-50A units and for the sender ID in the body of error
messages.
(3) In the [Unit of temperature] field, click to select either Celsius ( C) or Fahrenheit ( F). This setting decides the
temperature unit for the temperature setting and room temperature display that appears on the G-50A main
unit and the browser window.
(4) When [Get from G-50A] is clicked, the G-50A production ID will appear in the [SERIAL No.] field and the
G-50A program version will appear in the [Program Version] field.
Get from G-50A
Read basic setting content from G-50A.
-8-
Unit Setting
Set the G-50A name and unit ID.
(Refer to section 5-1-1)

Network Setting

Set the G-50A IP address,
subnet mask and gateway
address.
(Refer to section 5-1-2)

M-NET Setting

Set the G-50A M-NET address,
presence/absence of K-Control
unit and machines to send
prohibited controller command.
(Refer to section 5-1-3)

External Input Setting

Set the G-50A external input
setting.
(Refer to section 5-1-4)
Set to G-50A
Send basic setting data to G-50A.