Router Settings; Enabling Vpn Passthrough; Upnp (Universal Plug And Play); Dhcp - NETGEAR Zing User Manual

Router Settings

Adjust your device's router settings through the Basic, Port Forwarding, and Port Filtering
tabs.

Enabling VPN Passthrough

If you want to connect to a corporate network using their VPN (Virtual Private Network), you
need to enable VPN Passthrough.
1. Log in to the home page. (See
2. Click Settings > Router > Basic.
3. Beside VPN Passthrough, select On.
4. Click Submit.

UPnP (Universal Plug and Play)

UPnP provides simple and robust connectivity among consumer electronics, intelligent
appliances, and mobile devices from many different vendors. (For more information, see
upnp.org.)
Note: If UPnP is enabled, there are potential security risks.
Enabling UPnP
Before you can use UPnP, you must enable it.
1. Log in to the home page. (See
2. Click Settings > Router > Basic.
3. Next to UPnP, select On.
4. Click Submit.

DHCP

DHCP (Dynamic Host Control Protocol) automatically assigns an IP address to each device on
the network and manages other network configuration information for devices connected to your
network. You do not need to manually configure the IP address on each device that's on your
network.
The assigned IP addresses are not permanent (as opposed to when using static IP).
Most ISPs (Internet Service Providers) use DHCP.
Normally, you should enable DHCP, in which case you must configure each device on the
network with one of the following:
Device Settings
Logging In as an Administrator.)
Logging In as an Administrator.)
94