Configuring Storage; Configuring Schedules For Storage - Honeywell HEN04111 User Manual

190 | Embedded Network Video Recorder User Guide

Configuring Storage

Click the Storage arrow to expand the Storage selection tree.

Configuring Schedules for Storage

You can add or remove schedules for recording.
There are four recording modes: General (auto), Motion Detect, Alarm, and MD&Alarm.
1.
www.honeywell.com/security
Table 5-21 Configuring for Abnormalities
Configuration
Event Type
Enable
Alarm Out
Latch
Show Message
Alarm Upload
Send Email
Buzzer
Click Schedule in the Storage selection tree to open the Schedule configuration
interface.
Description
Select from No Disk, Disk Error, Disk No Space, Net
Disconnection, IP Conflict, and MAC Conflict.
Less Than: (For No Space configuration only) Configure the
minimum percentage of free space on the disk. An alarm lets
you know when the disk capacity is low. You need to click to
enable this function.
Click to enable this function.
Select the device output port, from 1 to 3. Select the
corresponding port(s) so the system can activate the
corresponding alarm devices when an alarm occurs.
The system can delay the alarm output for a specified time
after an alarm ends. The value ranges from 1s to 300s.
Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
The system can upload the alarm signal to the center
(including the alarm center).
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
 
Menu Setting Network
settings. See Configuring Email Settings on page
Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.

Email to configure the email
173.