Installation And Accessory Parts - Haier RF-8888-395 Service Manual

INSTALLATION AND ACCESSORY PARTS

Unpacking Your Wine Cooler
1.Remove all packaging material, This includes the foam base and all adhesive
tape holding the wine cooler accessories inside and outside ,compressor from
shipping damage due to vibration and shock.
2.Inspect and remove any remains of packing ,tape or printed materials before
powering on the wine cooler.
Leveling Your Wine Cooler
Your wine cooler has four leveling legs which are located in the front and rear
Corners of your wine cooler . After properly placing your wine cooler in its final
position ,you can level your wine cooler.
Leveling cooler or by turning them clockwise to lower your wine cooler, The wine
cooler door will close easier when the leveling legs are extended.
Proper Air Circulation
To assure your wine cooler works at the maximum efficiency it was designed
for ,you should install it in a location where there is proper air
circulation ,plumbing and electrical connections.
The following are recommended clearances around the wine cooler:
Sides..............2"(50mm)
Top ................2"(50mm)
Back..............2"(50mm)
Do not over fill your wine cooler for proper internal air circulation.
INSTALLATION AND ACCESSORY PARTS
£ ¸