Kia Automobile User Manual page 44

Knowing your vehicle
1
2
3
4
4. Position the lap portion of the belt
5
across your lap as LOW ON THE
HIPS as possible to reduce the
risk of sliding under it during an
6
accident. Adjust the belt to a
SNUG FIT by pulling up on the
shoulder portion of the safety belt.
7
The belt retractor is designed to
take up excess webbing automati-
8 cally and to maintain tension on
the belt. For your safety, do not put
any excess slack into the safety
9
belt at any location.
3 34
B200A02NF
5. Adjust the shoulder anchor posi-
tion to your size. To raise the
anchor position, push the anchor
up ( 1 ). To lower the anchor posi-
tion, press ( 2 ) the button and slide
the anchor down ( 3 ). After adjust-
ment, make sure the anchor is
locked in position.
If the height of the adjusting seat belt
is too near your neck, you will not be
getting the most effective protection.
The shoulder portion should be
adjusted so that it lies across your
chest and midway over your shoulder
nearest the door and not your neck.
WARNING -
• The height adjuster must be in
the locked position when the
vehicle is moving.
• The misadjustment of height
of the shoulder belt could
reduce the effectiveness of
the seat belt in a crash.
OUN026100
Beld adjust