Table of Contents
Advertisement
Installation and Operation, cont'd
Min/Max LED (TP T 468 only) — This front panel LED blinks
3
red momentarily whenever the minimum or maximum limits of
the horizontal shift control (
turning the horizontal shift control knob in the same direction
after the limit has been reached will cause the LED to
continually blink.
For details on the ID bit (TP T 15HD A and
TP T 15HD AV) or Monitor/No Monitor (TP T 468)
and DDSP switches, see "Computer video and PC
audio," earlier in this chapter.
Troubleshooting
If the image does not appear
1.
Ensure that all devices are receiving power. The
transmitter's and receiver's front panel Power LEDs
indicate that they are receiving power.
2.
Ensure that the transmitter is receiving a video input.
Ensure that the TP cable(s) are properly terminated in
3.
accordance with TIA/EIA T 568A standards and that the
RJ-45 connections are securely made. If the Power LEDs
on the transmitter and the receiver are lit green, a
transmitter is properly connected to a receiver.
4.
For computer/RGB video, ensure that the receiver's SOG
and C Sync switches are in the correct positions for the
video output.
5.
For computer video, ensure that the transmitter's ID bit
switches are on.
6.
For computer video on an LCD projector, ensure that the
transmitter's DDSP switch is on.
7.
The transmission distance may be too far for remote
power. Try connecting the local 15 VDC power supply to
the transmitter.
8.
The transmission distance may be too short. Ensure that
the UTP cable is at least 50' (15.2 m) long.
9.
If the Manual/Auto switch is in the manual position,
ensure that the receiver's level controls are not set too
high. Too much level and peaking can cause display
problems.
2-30
Extron TP Transmitters • Installation and Operation
) have been reached. Continually
2
10.
For computer video from a laptop or for ungrounded AC
distribution systems, the transmitter may need to be
grounded. See "Grounding the transmitter," earlier in this
chapter.
11.
Call the Extron S
3
Sales & Technical Support Hotline if
necessary.
If the image is not displayed correctly
1.
For computer/RGB video, if the output image looks too
green, ensure that the receiver's SOG switch is off.
For computer video, if the picture hangs off the edge of the
2.
screen, adjust the transmitter's H Shift control.
DDSP disables the horizontal shift control.
3.
Place the receiver's Manual/Auto switch to manual and
adjust the level and peaking controls for optimum quality.
4.
The transmission distance may be too far for remote
power. Try connecting the local 15VDC power supply to
the transmitter.
For computer video from a laptop or for ungrounded AC
5.
distribution systems, the transmitter may need to be
grounded. See "Grounding the transmitter," earlier in this
chapter.
6.
If the image still does not display properly, call the Extron
S
3
Sales & Technical Support Hotline. (See the rear cover
of this manual for the phone number for your region of the
world.)
If the receiver's Manual/Auto LED flashes
1.
The transmission distance may be too far for remote power.
Connect the local 15VDC power supply to the transmitter.
2.
Check the RJ-45 connector for a loose connection.
Extron TP Transmitters • Installation and Operation
2-31
Advertisement
Table of Contents
