Mitsubishi Electric MXZ-2D33VA-E1 Service Manual page 104

OPERATING PROCEDURE
2. Removing the outdoor control P.C. board the out-
door power P.C. board and the noise filter P.C.
board
(1) Remove the service panel.
(2) Remove the top panel, the front panel, and the rear panel.
(3) Disconnect all connectors and lead wires on the outdoor
control P.C. board.
(4) Remove the outdoor control P.C. board.
(5) Remove the screws fixing the outdoor power P.C. board.
(6) Disconnect all connectors and lead wires on the outdoor
power P.C. board.
(7) Remove the outdoor power P.C. board.
(8) Disconnect all connectors and lead wires on the noise filter
P.C. board.
(9) Remove the noise filter P.C. board.
3. Removing the reactor
(1) Remove the top panel (Photo 1).
(2) Disconnect the reactor lead wire.
(3) Remove the screws of the reactor, and remove the reactor.
4. Removing the fan motor
(1) Remove the service panel, the top panel, and the front
panel (Photo 1).
(2) Disconnect the connector CN931 and CN932 on the out-
door control P.C. board.
(3) Remove the propeller.
(4) Remove the fan motor.
OBH626B
Photo 4
Screws
of the
electrical
parts
Photo 5
Photo 6
Screws of the outdoor fan motor
Propeller
Propeller nut
Separator
104
PHOTOS
Screws of the reactor
Sound
proof felt