High Beams - BMW M6 Owner's Manual

is a danger to life and limb when work is carried
out improperly.<
High beams, parking lamps
The illustration shows the front left side of the
engine compartment.

High beams

55-watt bulb, H 7
1. Remove the cover cap 1 by pressing the tab
and removing the cover cap upward.
2. Press the bulb holder from above to release
it.
3. Remove the bulb holder.
4. Remove and replace the bulb.
The lamp H7 is pressurized; wear eye
protection and protective gloves. Other-
wise, there is a danger of injuries if the bulb is
accidentally damaged during
Parking lamps
10-watt bulb
Bulb holder and reflector are one unit and
are replaced together.<
1. Turn the bulb holder 2 to the right and
remove.
2. Press the snap connection on the plug con-
nector, pull off the bulb holder and replace.
Front turn signals, side marker
Your BMW is equipped with two turn signal
lamps per side in the front.
208
Online Edition for Part no. 01 41 0 012 830 - © 08/06 BMW AG
Turn signal lamp 1
21-watt bulb, WY21SV
The illustration shows the front right side of the
engine compartment.
1.
2.
3.
Turn signal lamp 2
21-watt bulb, WY21SV
The bulb for the turn signal lamp 2 can be
replaced via the wheel well.
The illustration shows the front left side of the
vehicle.
1.
replacement.<
2.
3.
Press the lever shown:
> downward for the right turn signal
>
upward for the left turn signal
Remove the bulb holder towards the rear.
Remove and replace the bulb.
Steering turned all the way to the left or
right.
Turn off the light, switch off the ignition and
remove the remote control from the ignition
lock.
Unscrew the bolt 1 with an open-ended
wrench.